You could also try reading the instructions. Im guessing that the dial with the bulb on it is the hi-lo sensor, this determines the how bright the light comes on when it goes dark(how dark is determined by the sun-moon dial), when the PIR is activated the light will go to full brightness for the length of the timer. Most outdoor lights come with a particular bulb. For instance, LED lights tend to last longer than incandescent lights, but they also cost a lot more than most incandescent lights. There are pros and cons to each bulb type. Fluorescent: Light is produced by a chemical reaction. If it does it should stay off until its dark. Incandescent: Light is produced by a heated wire filament. The best bet is to turn the time right down, set the dial to the moon and see if it goes out after a minute or so. LAP Weyburn Outdoor LED Floodlight With PIR Sensor Black 10W 1000lm (433PG) (211) compare. The sun and moon are the level of daylight that you want the light to come on at, point it to the sun and it will operate all day, point it to the moon and it will only operate in the pitch black, probably 3/4 of the way round is about right. Possibly, but if one of the dials underneath has a sun and a moon then probably not. You need to remove this sticker for it to So now we're pretty much out of ideas.Take a look under the PIR and you will see a little Last night this seemed to have cured the problem, but tonight it has returned. So I think we can safely assume that the sensor is definitely seeing something, but the question is what? I've also now adjusted the light position as there was some heat radiating from the bulb towards the sensor, and covered the top half of the sensor, which covers long range detection. Next I wondered about electrical interference or a fault with the sensor, so covered the entire sensor. I also tried covering up the nearby water butt, as I have heard that pools of water can cause false triggering. ![]() So then I tried covering the right side of the sensor, but the problem still continued. The problem continued, leading us to believe it was picking something up on the right. So we tried covering the left side of the sensor. We considered the possibility of the nearby boiler flue being the cause, but it often triggers when the boiler is off. There was absolutely no wind that night, everything was completely still. ![]() First thing I did was to check for anything moving, but couldn't see anything. It keeps coming on for no apparent reason. In the circuit there is also an extractor fan with its. Inside the pull switch there is a single red, black and earth wire. So I think we can safely assume that the sensor is definitely seeing something, but the question is what? I've also now adjusted the light position as there was some heat radiating from the bulb towards the sensor, and covered the top half of the sensor, which covers long range detection. I’m getting fed up with being woken up with the noisy pull cord every time one of my kids goes to the toilet in the night so thought fitting a motion detecting switch would solve the problem. ![]() Often referred to as strip light bulbs for their linear shape, tube light bulbs are. We considered the possibility of the nearby boiler flue being the cause, but it often triggers when the boiler is off. Motion Sensors LED Drivers Fluorescent Starters View All Bathrooms. ![]() Hi, hope someone can help us with out security light.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |